Bei meinem Drucker Canon iP3300 blinken die Starttaste und die Alarmtaste nach dem Start abwechselnd,auf dem Bildschirm erscheint die Fehlermeldung 5C00,das Papier wird nur halb eingezogen,der Schlitten mit Druckkopf und Druckerpatronen bewegt sich nicht, auch nicht wenn ich die vorder Klappe öffne, wo sich der Schlitten normalerweise in die Mitte fährt.
Hallo Witzworter,
ich kenne den Blinkcode leider nicht, es hört sich aber evtl. nach einem blockiertem Druckkopf an.
Könnten aber auch etwas anderes sein wie z. B.
voller Tintenauffangbehälter, da machen die Canondrucker auch nicht mehr viel. Du musst erstmal
den Fehlercode interpretieren.
Das hier habe ich im Internet gefunden:
Fixing this error is much easier as it looks.
-
Unplug the printer completely.
-
Move the ink cartridge cradle gently to the left.
-
Over to the right at it’s usual resting place you will see a small pad about 1cm square. This pad and the area around should be covered with ink.
-
Get a microfibre cloth and press down on this pad - it’s not fixed so should come away with the cloth, otherwise use tweezers gently.
-
Squeeze the pad several times between your thumb and forefinger while inside the microfiber cloth to remove ink build up.
-
Then when not much ink comes out on the cloth, clean the area in the printer around the pad so that looks free from ink too.
-
Then position the pad back in place, move the cradle back into position, plug in and switch on - should work fine now.
But it’s worth checking for any paper caught near the ink pad as my error occurred after a paper jam. Good luck