Hallo!
Meine neue Festplatte machte so seltsame Klack-Geräusche. Da habe ich mir das Programm HDD Health installiert. Seitdem kommt immer ein kleines Fiepsen und das folgende Fenster.
http://img529.imageshack.us/img529/13/hddph7.jpg
Was ist da los?
Ich hoffe jemand kann mir helfen.
Wenn jemand zur genaueren Beurteilung noch das LOG sehen möchte:
Drive model SAMSUNG HD501LJ
Drive capacity 134,2 GB
Drive serial number S0MUJDWPC08073
Firmware revision CR100-12
Number of cylinders 16383
Number of heads 16
Number of sectors per track 63
Number of LBA sectors 268435455
DMA support Enabled
LBA support Enabled
IORDY support Enabled
ATA software reset Not required
Overlap operation Supported
Command queuing Not supported
Interleaved DMA Not supported
Multiword DMA mode supported Mode 2 and below
PIO transfer mode supported Mode 4
Minimum Multiword DMA transfer cycle time per word 120 ns
Manufacturer’s recommended Multiword DMA transfer cycle time 120 ns
Minimum PIO transfer cycle time without flow control 120 ns
Minimum PIO transfer cycle time with IORDY flow control 120 ns
ATA standard version ATA/ATAPI-8 and below
ATA realisation version 0052h
SMART feature set Supported, Disabled
Security Mode feature set Supported, Disabled
Removable Media feature set Not supported
Power Management feature set Supported
PACKET Command feature set Not supported
Write cache Supported, Enabled
Look-ahead Supported, Enabled
Release interrupt Not supported
SERVICE interrupt Not supported
DEVICE RESET command Not supported
Host Protected Area feature set Supported
WRITE BUFFER command Supported
READ BUFFER command Supported
NOP command Supported
DOWNLOAD MICROCODE command Supported
READ DMA QUEUED and WRITE DMA QUEUED commands Not supported
CFA feature set Not supported
Advanced Power Management feature set Not supported
Removable Media Status feature set Not supported
Power-Up In Standby feature set Not supported
SET MAX security extension Supported, Disabled
Automatic Acoustic Management feature set Supported, Disabled
48-bit Address feature set Supported
Device Configuration Overlay feature set Supported
FLUSH CACHE command Supported
FLUSH CACHE EXT command Supported
SMART error logging Supported
SMART self-test Supported
Media serial number field words Not supported
Media Card Pass Through Command feature set Not supported
Streaming feature set Not supported
General Purpose Logging feature set Supported
WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands Not supported
WRITE DMA QUEUED FUA EXT command Not supported
World wide name Supported
URG bit for READ STREAM DMA and READ STREAM PIO commands Not supported
URG bit for WRITE STREAM DMA and WRITE STREAM PIO commands Not supported
Time-limited Read/write feature set Not supported
Read Continuoud and Write Continuous in the Time-limited Read/write feature set Not supported
Ultra DMA mode selected Mode 6
Ultra DMA mode supported Mode 6 and below
Master Password Revision Code Not supported
Device vendor’s recommended acoustic management level 0
The current automatic acoustic management level 254
Removable Media Status Notification feature set Not supported
Enhanced security erase unit feature Not supported
The security count is expired and SECURITY UNLOCK and SECURITY ERASE UNIT are command aborted until a power-on reset or hardware reset.
Maximum average RMS current 1101 Milliamperes
Start/Stop Count (Power on count) 44 times
Reallocated Sectors Count 0 sectors
Power-On Hours 642 minuties (hours)
Device Power Cycle Count 23 times
Temperature 30 °C
Reallocation Event Count 0 events
Current Pending Sector Count (Unstable sectors) 0 sectors
Uncorrectable Sector Count 0 sectors
UltraDMA CRC Error Count (total) 0 errors
Write Error Rate (Multi Zone Error Rate) 0